Update on the new tabletop piece - Assembly is 99% complete.
There’s only one little thing I still have to attach - The rolled drum that goes around the center of the clock is just sitting on the interior lip between the two plates. I’ll need to drill, tap, and screw the drum to that lip. Right now, if you look carefully at the top (especially in the first photo) it tapers a little instead of having a consistent gap. That’s because it’s lifting off it’s seating a little. But it has some flex, so once it’s fastened it’ll be be good to go.
Next step is to grab the rotary grinders and make these flat pieces into a 3D sculpture.
